Alignment Guide for a Feather Edge Fence (or a Close Board Fence)

This is a simple alignment guide to help you build a Feather Edge (aka Close Board) fence using boards 125mm wide. I catches on the pervious board and gives you a 25mm overlap. Also, the front edge of the build is where to put the nail to hit the narrow end of the board beneath.

Simple design but was very useful when I did my fence this weekend!

Print instructions

Not particularly fussy. I printed it at 0.3mm 15% infill in Prusament PETG since I thought it might survive better if I missed the nail with the hammer! However, it will be fine in PLA as well. Orange was to stop it getting lost in the grass.