D-Bot Bondtech BMG Carriage for E3D Volcano

EDIT 07/13/2020: I have tested these parts and found that while I did manage to get some decent looking prints there were some artifacts that seem to be caused by one of the wheels being loose.

For some reason I can't seem to get all four wheels tensioned properly so I intend to design and test a 3 wheels variant.

F3D Archive and STEP files for this design have been uploaded to allow for easier modifications should anyone wish to do so.

While working on my DBOT I couldn't find a direct drive carriage for the DBOT that was designed to fit the Bondtech BMG extruder and the BLTouch in a configuration that I liked so I remixed a few parts.

I also added a spot to insert some 3mm nylon into the cable mount to help support the cable bundle.

DBOT Probe offset:

X: +30.9
Y: +31.6

Print instructions

The Fan Duct needs support on the build plate only below the fan inlet and support arm. I used PrusaSlicer to customize and limit the supports to that area.

4 perimeters