Retro Playstation Pi Usb Hub Holder

Scope

This is a usb hub holder for the original Playstation 1 case.

About

I was building a Playstation Pi Retro console, but wanted have usb ports on the back as well, to connect wireless receivers. Therefore I designed this outlet to hold a little usb hub. It fits the playstation casing perfectly. In order to have the corresponding space for the usb-hub I removed the ethernet cable as well es analog audio jacks, from the original Playstation Pi design.

Usage

The hub will be connected to one of the USB-Ports of the Raspberry Pi, while one of the inner usb connections of the hub will be redirected back to the front panel. Therefore you do not loose any of the four front facing USB-Ports, even though the Raspberry only has 4 ports total.

Additional parts

I used the following usb-hub as inlay for this part:

• USB 2.0 Hub Smile 4-Port

Print instructions

Category: Electronics Print Settings

Printer: Anet A8

Rafts: No

Supports: Yes

Resolution: .2

Infill: 100%

Notes:

Due to the horizontal circuit board holders supports are recommended