Philips Hue Remote Wall Plate/Cradle (with original light switch accessible)

Wall plate for the Philips Hue Remote designed to fit over a standard US light switch (rocker style).

The remote mounts to the plate using common Neodymium magnets found on eBay, 10mm diameter, 3mm thickness, 3mm hole and are hot glued into place.
https://www.ebay.ca/itm/153760102797

I tried making the magnets permanently inside the print but I could not get it to work. Feel free to remix for different magnet sizes!

This is separated into two pieces to allow the surface finishes that you interact with to be the finished (build plate) surfaces. You will need to use super glue to glue both parts together prior to installation. I used off-the-shelf Krazy Glue.

Print instructions

Print with PETG (or PLA if you have strong bed adhesion)
0.2 or 0.3mm layer height depending on desired quality
20% Grid infill
Supports not required