Printer Scraps Bin

A trash bin to keep around the mini (or other printer) for the waste that comes of a print - be it skirts, brim, supports or even failed prints.

Designed to test the vertical height of the mini and spiral vase mode - give it a try and you may be surprised at the quality and durability of the results.

Print instructions

You must print this in Spiral Vase mode!
Print Settings --> Layers and Perimeters --> Vertical shells

0.15mm layer height works well, 5+bottom layers to give it a bit of strength.

Should be a very stable and reliable print that fills the vertical (Z) axis of the mini without using up too much filament.