Universal and stable Phone Stand
Universal and stable Phone Stand
3D
Published 2022-02-28T09:19:21+00:00
I always wanted a simple / cool / stable phone stand for my desk. Nothing much, but also - not too little. So i made one for my needs and decided to share. The issue with the most stands i saw - it was wayyy too easy to tip them over if the phone is a bit biger, or if you accidentally touch it with something or tip in to one side - so i added an excessive back support, that also looks good.
I used these settings -
Ender 3 V2:
0.2mm quallity,
20% infill - Absolutely no need for more
Adhesion:ON
Supports:ON
NOTE:
I used supports, but i think it might be ok to print without them. Let me know if you'v tried. Print time is 8 Hours, but i am certain it can be done a lot faster by adjusting the settings as it is an easy print.
| Date published | 28/02/2022 |
| Material Quantity | 64g |
| Dimensions | 142.5 x 137 x 103.3 |
