REGNUM BATTLE TANK
This object is currently under review. We cannot guarantee its printability just yet but this object is shareable and people with this link will be able to see and download it. If you would like to help us guarantee the printability of this object, please upload a picture of it printed.
REGNUM BATTLE TANK
3D
Hailing from the forge world Vexilum prime this armored beast is the prized STC of the planet ,with its modified auger array and advanced cast plasteel plates and rivets it formed the back bone of countless regiments of the Vexilum system.
The main inspiration for this build was the French Char B1 tank ,and a bit of cold war era tanks ,my main goal was to make it easy to print on FDM printers ,and i think i did that job well.
In this kit you will find 6 main gun options,5 sponson weapon options,armored and unarmored tracks,and 2 pintle weapon options.
The tracks an the turret are attached to the hull with ,,pegs,, .
Sponson turret has some free movement so you can position it however you like .The main gun should snap in place and have a bit of free vertical movement so you can elavate it however you like .
(If this is not the case try rescaling the x or y axis by +/- 2%)
All models are oriented I'm a way too achieve
most successful prints .
3D PRINTING SETTINGS
Printers used : ender3 ,CR10 V3
layer height:0.14mm
infill :5%(cubic)
wall thickness:1mm(can maybe go lower??)
print speed: 50mm/s
bottom layers count:3
top layers:4
supports :yes
support density:5%
brim :not necessary
material :PLA
print temperature :195-200 C
Please dial in your retraction and make sure your filament isnt moist ,if you dont have your retractions settings on point rivets will turn out goopy and sloppy and it wont look good ,if you have problems with stringing reduce the temperature or fiddle with the retraction settings .
| Status | Under Review |