3D Scanner

After finding the source code to a 3D scanner turntable on the internet I decided to make my own design of a 3D scanner setup.

All credits for the source code goes to Whitney Potter for making the code.
Source Code can be found here
https://cdn.instructables.com/ORIG/F59/07PC/IJUCSTEF/F5907PCIJUCSTEF.zip
I have also included my sketch settings under thing files for you to download. The setting may vary depending on the gear ratio you choose to use.

Here is a list of the electronics you need to make this scanner.

Any Camera will work as long as you can set the ISO and EXP manually

A stepper motor with a driver like this one on eBay (28BYJ). Remember its week so you need to use bearings and nothing must touch anything else so the turntable is free from friction.
https://www.ebay.com/itm/1PCS-5V-Stepper-Motor-28BYJ-48-With-Drive-Test-Module-Board-ULN2003-5-Line-4-Pha/191877872096?epid=532472843&hash=item2caccff9e0:g:SY4AAOSwbPxXQBI3

Any Arduino will work but to fit this design you need to use an Arduino Uno
https://www.ebay.com/itm/UNO-R3-Development-Board-Microcontroller-MEGA328P-ATMEGA16U2-Compat-For-Arduino/292039556849?epid=503214088&hash=item43fee9fef1:g:AC8AAOSwhlZYs4iW

Arduino LCD Shield with Keypad
https://www.ebay.com/itm/1602-LCD-with-Keypad-Shield-Board-Blue-Backlight-for-Arduino-Duemilanove-Robot/201556596016?epid=23022375794&hash=item2eedb59530:g:aC0AAOSwfl9XA42K

IR Diod
https://www.ebay.com/itm/10PCS-5mm-940nm-IR-infrared-Launch-emission-tube-diode-LED-Lamp-Emitting/191736129142?hash=item2ca45d2676:g:vzkAAOSwgZ1XusHk

A GT2 Timing belt
https://www.ebay.com/itm/2Pcs-GT2-Timing-Pulley-20T-5-8mm-79-2M-Belt-6mm-width-kit-For-3D-Printer-Reprap/131817122932?hash=item1eb0e9ac74:m:moSn-D5J-22NfQIXXfzWKMA

2 pcs 2287 beraings
https://www.ebay.com/itm/10pcs-ID-Bore-8mm-22mm-7mm-608ZZ-Ball-Bearing-608Z-High-Speed-Bearings-Useful/122478839007?hash=item1c844ec4df:g:2WkAAOSwISNbl3BI

Print instructions

Category: DIY Post-Printing