Hypercube Support for Bedisolation

If you want to isolate your heated bed with silicon wool, you will notice that this stuff doesnt adhere well to the common 3M strips or the likes; it will just peel itself off.
So, since we already have kind of an underconstruction to just put the silicon wool between this and the heated bed, i just needed something to put some support in the middle.

I designed this for the standard Cube Anet A8 Construction, but i think its also fitting for the standard Hypercube Evolution.

I measured 140mm in length, and so i designed this to be a tad longer (142mm i think), so
it presses the wool a tad up.
If you have an underconstruction of another size, just measure that out, and scale that up in the cad of your choice.

Print instructions

Category: 3D Printer Parts Print Settings

Printer: CubeAnet A8

Rafts: No

Supports: No

Resolution: 0.3

Infill: 15%

Filament: Owl Filament PETG Red
Notes:

The Filament isnt good, but for functional prints like that its good enough.