Oo Wagon Top pack 1 (swappable tops)

this is the first wagon pack that goes along with my Swapple top chassis. they all use the same items that allow them to be compatible with the chassis. these are simple plank-styled wagons, not heavily detailed. mainly meant to help fill your layout with simple models. if your try to count their rivets you will find they have, well, 0.

they were designed to fit on a chassis based on the Tri-ang open-top truck.

in this first pack, you will find it has the following models for download

• 7-Plank wagon
• Box van
• Tanker

Chassis

• https://www.thingiverse.com/thing:5065167

if you like this model and you are able to, a donation to the is appreciated, thank you.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Resolution:

0.15 or less

Infill:

less then 5%

Filament: Generic PLA Your Choice

Notes:

the only parts that need supports are the tanker and roof to the box van. only support to the bed for these parts is required.

Post-Printing

assembly

Every truck will need an 8mm magnet for every top. every top will need at least one peg to be secured in place but two is optimal.

once everything is printed put the magnet in the center hole and make sure it will snap with the magnet in the chassis, if not, remove one of them and reverse them. then shove the pegs into the other two holes and glue them in place, if you are struggling with this, try removing some material from the top of the peg and try again, be careful though. the pegs are 6mm in diameter.

now for specialized instructions for the other tops

7-plank wagon:

no extra steps, to straight to painting.

Box van:

put the roof on top and glue in place if you want.

Tanker:

paint model to desired colors and decals. after the paint dried, glue the frame ends to the ends. finally, take thin wire or string and thread wire through the holes as you desire.