Folgertech FT-6 noise reduction

This is a kit to help with the noise in the parts in Ft-6 prints

The problem I ran into is that the Two motor breakout board for X axis seems to backfeed

power between the two motors and adds noise in the print and limits the speed

This can cause you to have to have larger than necessary retracts that can lead to jams

mod requires a 5 driver board and Blinkingsun's Y carriage so you can run both X motors

independently with the makerbot limit switch with m3 hardware

The pulleys replace one belt clamp on each of the Y carriage to keep light pressure to damp belt vibration

using Flange Ball Bearings 3x10x4mm and m3 hardware

Also change X axis pulleys from smooth to 16 toothed ones

Please leave a comment after trying any of these mods

-Did it help?

-Did it fit your printer?

-Was it a waste of time?

-Was it the fix you needed?

Print Settings

Rafts:

No

Supports:

Yes

Resolution:

.2

Infill:

25

Filament: amazon Petg Black