Galaxy Note10+ and Galaxy Watch dock

Charging station for Galaxy Note10+ and Galaxy Watch

The hole for the watch charger is 47mm, should fit most galaxy watch chargers.

What I changed from the original:

Made the phone holder 3mm wide and deeper, as to fit my phone case.

Made the watch charger hole bigger so my watch charger could fit

Added notches into the left piece so the right side will snap in, instead of tape or glue

If you can use Simplify3d, remove the supports from the holes on the left side piece, as in mine it printed fine without. You might have to trim the right side pins so it will fit the holes. I adjusted it after I printed mine, so you might not have to.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

100

Infill:

15

Filament: Sunlu PLA Black