Blinds rod end part

I broke my blinds.

I fixed my blinds.

This fits into the 1/4" hole where the plastic part that hooked to the turning mechanism broke.

I just super glued this part in. If it breaks again, I can just snip it off and glue in a new one.

This file will print two end pieces. The prints will be better quality by printing two at a time, since it is so small. It only takes about ten minutes total, so no big deal.

I printed at .20mmlayer height, 3 perimeters, tops, and bottoms. No support needed. Print as oriented in the file.