COMX-35 / PC1 expansion card box

Those who still own a COMX-35 or PC-1 and have a broken expansion casing, are designing some form of expansion card or building one from AVI (www.comx35.com) now can print a new one with a 3D printer. Slightly adjusted to make printing better :

• Side are now straight because it is not spray molded anymore
• Both bottoms are flat to prevent hanging of filament
• Pins inside the lid are thicker to prevent breaking off
• Side lockers have extra back plate to prevent breaking off
• COMX logo is not deep enough still, will post a revised one later.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

No

Resolution:

0.12 mm

Infill:

20%

Notes:

No supports needed. Print laying on top of lid and bottom of bottom.
Speed 50 mm/s

Layer thickness 0.12 mm

First layer 0.08 mm

Extruder head 0.4 mm

Extruder temp 200 degrees celsius

Heatbed 55 degrees celsius

How I Designed This

My father-in-law,John Heggen (www.anjobest.hobby-site.com) made this from the original with Solidworks so all the credits for the design go to him !