Happy Snowman Christmas Holiday Ornament & Gift Box, 2020, 2021, 2022 & No Year

UPDATED: for those wanting to get a jump on the 2022 holiday season :), I have included a 2022 version.

These are "2020", "2021", "2022" & (no year) Happy Snowman Christmas holiday ornaments & gift boxes with a gift compartment. There are four different ornaments, each with a front and a back half. They are hollow and in a clamshell design so that gifts or additional items, such as candy, electronics, lights, etc. can be placed inside.

These are based off of an earlier design I did, that had a snowman that wasn't very happy about the year 2020. It was also designed to hold a specific USB thumb drive inside. These ornaments have a thinner outside wall and they are a bit deeper, so that they can hold more stuff inside. I also modified the design so that the hat prints a little better and requires less post-printing clean up, but the design does require printing with supports, though only a minimal quantity are needed. The earlier design is:

https://www.thingiverse.com/thing:4673942 .

Printing: print the first layer at a slow speed to get good detail on the face, buttons and numbers. Print with support (for the hat). Avoid using a brim or raft, if you can; this will make clean up easier. If printing with glue stick on white filament, after printing wash the model to remove glue residue. The two halves fit together fairly tightly (at least with my printer); if they are too tight, lightly file and sand the connection posts to the desired fit.

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Resolution:

0.16

Infill:

15%

Filament: Overture PETG White Post-Printing =============

(see above)