JGAurora A5 Vibration Dampers

Remix of the CR-10 Vibration Dampers with a smaller diameter of 23mm, matching the rubber feet of the JGAurora A5. Tolerances allow for easy assembling.

These PLA vibration dampers help to significantly reduce printer noise, and in my personal experience have helped to noticeably eliminate ghosting/ringing in my prints.

Print Settings

Printer:

JGAurora A5

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.2

Infill:

20%

Filament:

extrudr PLA NX2

white

Notes:

The vibration dampers fit right under the stock rubber feet.

Print four of each part. No supports required if printed on edge - just use proper part cooling in the upper regions for good closing of the circular hole.

If not printed on a raft, use a brim with 6-8 lines for better bed adhesion.

Category: 3D Printer Accessories