Simple lighting solution

I was looking for a simple lighting solution to monitor and time-lapse prints and this is the result. It's only been on my printer for half a 20+ hour print but seems to be working well. The light listed below is motion/heat activated so it turns on when the lighting is low and a print is running (or it detects you) but turns off when not needed.

All all holes are sized for M3 screws.

These are the lights I used:
https://smile.amazon.com/gp/product/B06Y248YVJ/ref=oh\_aui\_detailpage\_o00\_s00?ie=UTF8&psc=1

Hope you find it useful.

Print instructions

Category: 3D Printer Accessories Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Notes:

3 perimeters to add some strength.