Easy peasy clip on phone stand

So I made this phone stand a while ago for my son. He watches small episodes of kids series in bed. He was struggling with holding the phone, not touching the screen but looking the series at the same time. You can choose 3 positions / angles. Works good. 

This model is made for a oneplus 7 with a width of 74,8mm. If you measure your phone width and multiply it by 1,35 you can take this as scale in your slicer. I did this with 3 phones and it worked pretty good.

This is not tested with any kind of cases.

I recommend PETG for this print as it stays flexible and won't deform over time.

I hope this works out for you too… you may have to tweak it a bit for your phone… the variety is just too big.