CR-6 SE Pi Camera V2.1 Mount

Ultimate minimalist Pi Camera V2.1 mount for the Creality CR-6 SE. No screws needed.

Simply insert the camera after print is finished, connect the cable and clip the two parts together. Then apply a little force to the clip at the level of the hex holes until it snaps into place. However, it could break during disassembly.
 

Printed in PLA with 0.16mm. Place the front with the front side on the print bed, the clip with the top side and best a brim and support.

Remix from evotodi's CR6 SE PiCam Right Mount