All Angle Phone Stand (Print In Place)

(Print settings below, and please make sure to check all the pictures I included!)

Aren't you sick of always seeing the same phone holder? The one that looks like a triangle, and has been reuploaded to both Printables and Thingiverse thousands, maybe millions of times? This one?

 

Well this is the perfect stand for you! This is a phone stand to keep your phone in the right position whenever you want. You can use it in the kitchen for when you are watching cooking videos, in your bedroom for when you don't want to hold your phone/tablet or just anywhere else you may need it! It even folds up so that you can put it in your pocket r bag and take it anywhere with you!

Like it says in the title this is a print in place print, no need to worry about assembling it. You can even set the print to 0.20mm speed and it will come out very good! 

Succes with your phone stand and happy printing!

Please check out my other stuff at my account!
https://www.printables.com/social/243307-klm1318/about

Print settings
Filament: Any (I used Esun PLA)
Printer: Any
Max resolution: 0.20mm SPEED
Supports: Supports for any angles above 45 degrees (Don't use supports in between the gaps of the hinges, that will probably be a pain to remove and make it hard to move the hinges)
Infill: Anything between 20% and 50%
Brim: Not advised

Filament usage
4,47 meters
10761,84 mm3 (cubic milimeters)
13,34 gram
Printing time on the settings above: 2h36m