[Titan] [Clone] LCitan (Low Cost titan case) - v1.2.1

Some time ago I did two Pitan (https://www.thingiverse.com/thing:2728600) extruders for my printers. These extruders worked very well, but I wanted know if is possible migrate from a Pitan to a Titan e3d cloned.

So I based my research from this thing https://www.thingiverse.com/thing:1727220

I tried to reuse the most count possible of materials, but nevertheless was necessary buy an aditional bearing to use into the idler.

List of materials:

• 1 x Kit Triangelab Gears for Titan: https://www.aliexpress.com/item/32807307266.html?spm=2114.12010612.8148356.45.1f5e55b4Hgpsh9)
• 2 x Bearing 695zz (d=5mm; D=13mm)
• 1 x Bearing MR95ZZ (d=5mm; D=9mm)
• 1 x Bearing 623zz (d=3mm; D=10mm)
• 2 x Screw M3x30
• 1 x Screw M3x25
• 1 x Screw M3x8
• 2 x Screw M3x8
• 1 x Spring 8x15x1mm
• Optional: 1 x bowden adapter (Example: https://www.thingiverse.com/thing:3569343)

Instalation:

It is too easy and intuitive to install, just follow the pictures but remember: there are just 2 things you must not forget:

1. Add the M3 nut below body
2. Adjust the M3x8 screw to hold the body

Updates:

v1.0.0: 2019 - 09 - 15

Warning: This project is still in progres, I could make works this extruder, but at this moment is a bit difficult to tighten the screws when the top is placed.

Also the turn beetween the gears are not too smoth

I am working in these improves.

v1.0.1: 2019 - 09 - 17

I performed some changes to improve the distance between gears, now the turn is much smooth. I think definitively there is not risk to use the extrusor. Feel free to test it :D

v1.1.0: 2019 - 09 - 21

Uploaded Mirrored versions.

v1.2.0: 2019 - 10 - 1

Added mount to use direct extrusion with Ender 3 (Use mirrored parts for this).

v1.2.1: 2020 - 04 - 16

Reinforced the spring container. After seven months I noted that the PLA had some cracks on that part.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.2 or less

Infill:

20% - 40%

Filament: Generic PLA Gray and Red