A5 2016 case

My phone was broken so I switched to this phone temporarily but couldn't find a case for it. So I made one. Has all the proper holes (even the top microphone)

Update: V2 is out, which has a better fit, making it snap into place with a satisfying click. Its a bit (1mm-->1.2mm) thicker but it is not noticeable.

Update2: V3 is out which fixes the charging port, it has a better fit again, moves the mic hole to line it up better, it's also stronger where the sides and the back connect, and some minor aesthetic tweaks.

Print Settings

Printer:

Lotmaxx Sc-10 Shark V2

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament:

Red

Notes:

No supports needed. Just rotate the part 180 degrees. Turn off combing in cura. It adds a lot of unnecessary moves that makes the print come out worse