LightHouse

Print and files are not for resale and not for commercial use.

It would be very much appreciated to consider a tip for the design as several hours involved in constructing, then splitting apart.

File and Prints of models not to sell or resale

NEW UPDATES

6 Feb 22 Added glass panel for top piece to be printed in clear filament, super glue in place.

5 Dec 21

New smaller Observation deck added. Original was 227 x 227, New is 220 x 220 to fit the bed size stated from the beginning.

4 Dec 21

New LightHouseTopBody uploaded to reduce amount of center supports. Original required support of whole ceiling. New requires closer to center. About 8-10% threshold what I saw in PrusaSlicer

3 Dec 21

1BodyA, 2BodyD, 3BodyB, 3BodyC, LightHouseTopBody have been updated due to finding an overhang at the bottom inside of each window sill.

A support structure added for LightHouseTopBody and must be imported as a modifier

Multi part split to fit 220mm x 220mm x 220mm build plate. Total build of model is about 1meter.

Battery box for AAA battery case )found on eBay) 25mm x 25mm x 52mm for 5mm LED/s.

Servo is powered from separate 5V source similar to AAA battery case or DC adapter.

May eventually create mount/pocket for second battery case for servo motor into 1stBody. Some parts will require support, but minimal. Recommend Prusa paint on.

Print Settings

Printer:

gMax Xt+ / SunLu S8

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

15%

Filament:

any