Alien Facehugger 30oz cup cozy
Alien Facehugger 30oz cup cozy
Published 2020-08-10T22:25:09+00:00
This is ainspired by a freind's coffee mug that was hand sculpted. I set out to do this to work with Meshmixer.
* This is a mod of my Alien Facehugger mug PLEASE READ the details below before printing.
https://www.myminifactory.com/object/3d-print-alien-facehugger-mug-83075
The idea is to print, paint and put it on a 30oz Yeti-style Rambler cup.
* The size is very dependent on a few variables I can't control! Like printer acuracy, material shrinkage and cup sizes.
* I recomend printing the top inch of the model and see if it slides up to near the top of the cup. Not over.
* If it doesn't... scale it. In -maybe- 1 or 2 percent increments. This size should be close to the 30oz Rambler that's NOT painted.
* This has a small contact area. If in doubt, use a skirt/brim.
* This is a little experiment and I didn't want to share it originally, so please keep that in mind. Enjoy.
-Shawn
Use plenty of supports.
The finer layers will look better.
Use at least 3 shell layers for all sides for best results.
Print top inch of model and see if it fits on your 30oz Yeti-style Rambler cup to close to the top. If it doesn't... scale it. In -maybe- 1 or 2 percent increments. This size should be close to the 30oz Rambler that's NOT painted.
Date published | 10/08/2020 |