PowerCon Power Distributor

V2 version adds possibility to mount two additional PowerCon outputs instead of third SchuKo-socket with adapter plate.

***********************************************************************************************

Was in need of a PowerCon power distributor for supplying some lights on a small stage (overhead). Insted of buying I just created this one.

I added a mouting position for half couplers (M10-Screw) that is separated from the power wires but with a hole to wire PE to the screw. Also I use some other diy distributors for stage floor operation with a switchable index-light so I added this here as well (20mm round snap in place). I can recommend double end sleeves with 9 cm of wire between the SchuKo-sockets (standard 50x50 mm sockets).

PowerCon and switch are wired with 4,8 mm Faston (shielded). For the index light and PE connection for the coupler I recommend Wago connectors.

Screws used: 

• 16 M4x16 for the SchuKo sockets
• 4 M3x10 for the PowerCon sockets
• 8 M3x12 to close up