CR6 SE hot end conversion to Anycubic Vyper V5 hot end

Someone asked if I could make some parts to adapt the Anycubic Vyper V5 hot end to a Creality CR6-SE. I never finished. This design still needs fan holders/ducts. They got rid of their CR6 before I finished. 

***NOTE- I run several CR6's, and I am fairly happy with the stock hot ends. I don't plan to convert any of my own machines. 

Also- I don't think the Vyper hot end is a standard V5 hot end. it has vertical threaded mounting holes and an additional ring at the top of the heat sink. I could be mistaken though. 

The parts included (see numbered picture for referance):

1) Heat sink to strain sensor adaptor (the arrows on the model point to the front of the printer)

2) Strain gauge sensor to gantry spacer. 

3) Extended Z sensor finger. 

I don't plan to support any further development of this conversion, just sharing the work I completed before I stopped. 

Good Luck!