FPV Pan Mount for Insta360 Go2 - Peanut Updated

###Update Oct 2021: New version forCaddx Peanut* (works with both!)*

After getting a Peanut I redesigned the mount to support both cameras. It leaves the back exposed to support the charging-while-flying backpack. I recommend using a thin strip of gorilla tape around the whole setup when flying for added safety in case your plane experiences a Rapid Unscheduled Disassembly.

Add pan to your FPV rig!

Use that rudder channel on your flying-wing for something!

Servo Selection

Get the TGY-R5180MG 180º servo and extend the PWM output to 700-2300 (on either your FC or transmitter). This gives you 270º of rotation!

Printing

The Caddx Nebula Pro version needs no support to print. The DJI Air Unit version needs support only on the front overhang. I print mine in the super strong HTPLA+ from Fusion Filaments.

There's two versions of each mount. OneID3.75 mm for most printers and anID3.5 version for super tight tolerance printers. Your first layer will probably interfere with it fitting on the servo horn, I use an exacto knife to chamfer the opening a little after printing. Bolt it on and you're ready to rock!

Post your make!

Please post 'em! Really! Take a quick cameraphone photo of your print in all its glory and show it off! Plus it really helps get this design out there to the world.

Message me on discord/telegram for

• customizations
• different engravings
• different variation ideas
• any issues: printing, design, fit, etc
• to show off / geek out about your result
• say howdy

Designing stuff is fun but interacting with cool people and hearing about their adventures is better. I can generate any variation / engraving easily, message me on discord/telegram and/or leave a comment and let's make your perfect version. I only ask that you post a make!

If you'd like the CAD or STEP file too, no problem. I've already helped a bunch of great folks! Send me a ping