Keyboard Case bluetooth
Keyboard Case bluetooth
Published 2020-03-02T14:31:55+00:00
This was made to protect a Jelly Comb bluetooth keyboard while in a backpack. The keyboard was 432mm(17") long by 127mm(5") deep. it went from 17mm to 7mm thick. I added 4mm for space in each measurment.
The clasp is made to use a small fabric type hair tie on each side to close it.
Printing Notes
This was printed at 0.2 layer height
5 walls & 16% Gyroid infill for strength.
I printed this vertical along the Y axis to minimize any potential sway (which I did not experience) I used a 25 line brim and it did not flinch.
I used standard support 'touching everywhere' that just added 4 tiny supports right at the clips.
One other side note, to give it some cushion once the walls were established I paused the print and placed double sided foam tape with just one side off on the very ends and resumed the print.
It was made for a very specific need but I hope someone might find a use for it.
Date published | 02/03/2020 |