Montini Crocodile Feast Trough (Lego Compatible)
Montini Crocodile Feast Trough (Lego Compatible)
Published 2020-01-10T18:28:37+00:00 • Remixed from Feast trough in the form of a crocodile, Montini building bricks One Pip Set (Lego Compatible)
Montini building bricks were produced from 1961 to 1969 in the Netherlands. They were originally made from soft, pliable polypropylene. The diagonal fins bend slightly around the pips of the other block.
puppenhausmuseum.de/montini-bausteine.html
Just like the vintage original Montini parts, these are compatible with classic Lego full height bricks.
Please do not mix these with original Montini parts. PLA is much harder than the original bricks, and the layer ridges act like sand paper. You will wear out the original Montini bricks very quickly.
I cut the art scan model in half so I could make a relief from this carving. Then I sliced it and combined the parts with Montini building bricks.
These are optimized for a 0.4mm nozzle. They are friction fit parts, so tolerances are important.
Before printing, check that the infill angle is across the diagonal fins. That will prevent sagging of the first layer of the top plate that has the pips.
These pieces need supports:
0_0_ra-feast-front.stl
0_1_ra-feast-front.stl
1_0_ra-feast-front.stl
1_1_ra-feast-front.stl
1_2_ra-feast-front.stl
2_0_ra-feast-front.stl
2_1_ra-feast-front.stl
2_2_ra-feast-front.stl
3_0_ra-feast-front.stl
4_0_ra-feast-front.stl
Date published | 10/01/2020 |