Pool Eyeball (Nozzle) Removal Tool
Pool Eyeball (Nozzle) Removal Tool
Published 2019-09-19T13:45:14+00:00
This tool fits into the slots inside a 1-1/2" MIP thread pool "eyeball" (aka nozzle) so you can unscrew or screw it in. Yes, it fits a Hayward SP1419D!
Note: Make sure to print this in a filament that's reasonably strong and rigid. Those old eyeballs can get calcified and be real tough to remove! I printed the (black) example in AmazonBasics Premium black PLA and it seemed strong enough.
Tip: If you can't unscrew the old eyeball with this tool (it just starts to bend) then you'll need to break out some self-adjusting pliers (e.g. Robo Grip or similar) and really go to town on the old eyeball center part. I had to break off a bit (notch) of the threads on mine and then whack it with some scrap wood and a hammer to free it from it's calcium prison. Of course, I used my tool to screw in the new one =)
Don't screw in the new eyeball in too tight! Also use some PTFE (Teflon) tape on the threads to make it easier to unscrew in the future.
NOTE: For commercial use just ask! I want folks to ask permission so I can know where it's being used.
The bigger the layer height the stronger it'll be. I used a 0.25mm layer height, six perimeters, and 25% gyroid infill for mine. If I had a bigger nozzle I'd go with even thicker layers for greater strength.
Date published | 19/09/2019 |
Time to do | - 45 minutes |
Material Quantity | 15.69 |
Dimensions | 57.3x100.28x4.3 |
Support Free | YES |