RC Buggie
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×RC Buggie
3D
**What you will need**
- 2 9V Batteries
- 2 NRF24L01 Tranciever Modules
- 2 Arduino boards (i had a mega and uno)
- 1 5V DC Shunt motor
- 1 5V Servo Motor
**Car Assembly**
*Frame*
Screw arduino mega to bottom of buggie frame
Screw servo motor to front of buggie frame on flattened shaft and connect to arduino
Mount 9V to upper rear frame
Mount NRF24L01 under 9V Battery and connect to arduino
*Front*
Insert front bumper
Attach wheel hubs to between the frame's bumper and the bottom bumper
Attach wheels onto hubs and close off with axle caps
Attach steering to hub peg and servo motor
*Rear*
Insert rear axle into frame
Attach tires
*Finish*
Insert seats
**Sanding Instructions**
Sand front tires until they are loose on the wheel hub
Sand wheel hub pegs until they are semi-loose on the bumper
Sand rear wheels only enough to fit tightly on the rear axle
Sand seats to fit tightly on the seat-pegs on the frame
**Remote Assembly**
Attach NRF24L01 Module to arduino uno (or other board)
Attach joystick module to arduino board
**Coding Instructions**
Read joystick x rotation and transmitt (and set) the servo motor angle to the rotation
Read joystick y rotation transmitt (and set) motor voltage to high or low based on rotation
Printed (what I could) with PLA and UV Senesitive Abs-Like Resin
You will need supports on the frame but not on the other objects (I have pregenerated supports)
| Status | Rejected |