AIR COMPRESSOR LASER ROCKER SWITCH
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×AIR COMPRESSOR LASER ROCKER SWITCH
20 Amp 12 Volt ON-OFF Rocker Switch
LASER ETCHED WITH TWO L.E.D. LIGHTS
Single Pole Single Throw ON-OFF Switch
Black hard surface rocker
Surface size is 2″ (50mm) x 1″ (25mm)
Standard size mounting hole 1.41″ (36mm) x .86″ (22mm). This is the standard size of most switch holes in modern vehicles.
Upper light is ON when the switch is pressed UP
Lower LED is independent and can be wired to separate dash light circuit.
Both LEDs have separate grounds.
No rear barriers between terminals.
Lower light Waterproof rating of IP66.
All symbols are laser etched directly onto the switch face to ensure long image life.
Visit here:- https://bit.ly/2XT8pHj
Status | Rejected |