Clip for Holding down Glass + Bed + PEI + Cork

Long and short clip to clip together a layer of cork, glass, printer bed and PEI all together. The little tooth goes on the bottom side and digs into the cork. You may need to adjust thickness of the clip based on how thick your cork is. I use this so I can have my PEI laminated to the glass and easily flip it over to print on the glass side for certain filaments. I tried to make the top part of the clip as thin as I could but if you have a bed levelling sensor or fan very close to the surface take care it doesn't bump the clips.

Print Settings

Printer:

FLSUN I3

Rafts:

No

Supports:

No

Resolution:

0.4MM

Infill:

90%

Notes:

I printed with armadillo nylon alternative filament. You will need something that is strong, doesn't warp and can handle the heat from the bed... ABS or maybe PC would be better.