Anycubic Vyper V6/Revo 6/Revo Micro Vise Mount

Remix of model “V6Adapter-3mmShorter_1.stl” from thing#4976966. 

UPDATE 9/2/22: Recently upgraded to a revo micro on my vyper and this mount works well for this model also. It's tightened down all the way and I had to use a shorter M3x12 screw at the rear to clear the fan plug on the breakout board.

The original file would become loose over time and permit the hot end to turn creating a z-wobble like banding pattern. I added holes for 2 m3x16 screws and 2 m3 nuts. The 2 halves clamp around the top of the E3D v6 hot end and screw into the factory leveling gauge using the factory screws. My E3D V6 Volcano hot end is now very secure and the banding pattern is gone.

Materials:

(2) m3x16mm screws

(2) m3 nuts

Print Settings:

Filament: PETG

Layer: 0.2

Infill: 100%

Supports: Yes, for areas touching build plate. I did not find that I needed to support the ledge inside nor for the screw holes.