Soda Stream Button

Replacement Button lever on the older SodaStream Machines. I have found a number of them on here, but most are simplified and not designed to be replacements as much as short term fixes. This one will replace the original cracked or broken part and will connect via the same way the original did. I should mention, I run my machine with a large CO2 tank and do not use a back cover. So I have not checked clearance when rear cover is installed.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

No

Supports:

Yes

.16 (any should work)

Infill:

40-70%

Any Any, but best would be PETG or ABS ](http://www.amazon.com/s?url=search-alias&field-keywords=Any+Any%2C+but+best+would+be+PETG+or+ABS&tag=thingiverse09-20) Any

Notes:

Make sure you have good layer adhesion. I printed this with Top of button down on bed, with majority of part supported.

Post-Printing

May have to ream out holes depending on your printer.

How I Designed This

My SodaStream button finally cracked and it was either design a replacement or buy a new machine.

Custom Section