Rails for basket

We had a lot of charging equipment laying on the  kitchen counter near our usual charging spot. Decided to tidy it up a little by placing everything in a storage basket we had laying around. That cleaned it up a little, but the basket still took up place, so we discussed having it underneath the counter instead. 

The basket, a 4.5l Star Basket,  has a nice straight ‘rail’ at the top with a small nudge underneath, so a rail wasn't too hard to design. I included a small stopper at the end so that you won't accidentally pull the basket all the way out. It's still room enough to ‘fiddle it out’ if you need the basket all the way off. 
 

I used Add:North Black PLA with standard Prusa 0.20 Quality print settings. Printed it on its side (with all the small holes down on the bed) with a small support enforcer under the stop block.