IQOS Heets Spender

This is a IQOS Heets Spender to organize the heets in a more beautiful way. I made a base and an extension to get more heets in one spender and print it with my Prusa.

There are 2 versions. One with pentagon holes, one without. I tried both, but with the pentagons I needed many support, so I only use the plain mode.

The plain ones needed support at the buttom, Prusa Slicer made this perfectly fine with default settings.

For better stability I've designed the connector between two towers.

I designed this with OpenSCAD and tried again to use variables for easier customization. Feedbacks are always welcome, as I'm new to designing stuff.

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Supports:

Yes

Infill: 

15%

Filament:
EcoPLA Tough PLA Black

Category: Organization