Simple (ziptie compatible) Cable Clips
Description
PDFAbout
Very nice and versatile cable clip model by ndl that I wanted to give even more use cases to.
They can hold a cable well enough by themselves, but holes for use with small zip ties allow you to prevent cables from falling out or being removed by going around the clip, also small “horns” stop the ziptie from sliding off.
To hinder the cable being pulled on in a public/edu environment you can also run the ziptie by the side of the clip squishing the cable tightly.
Settings
Printed using Ultimaker 3 on PEI covered glass bed with Ultimaker Tough PLA Black and these settings:
Nozzle Size: 0.8mm
Layer Height: 0.4mm
“Sprint” Cura profile
My settings show the viability to produce them quickly, but smaller layers/nozzles give a better result.
License
As the model this is based on is licensed CC BY-NC-SA 4.0, this is too.
Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0)
Free to modify and republish non commercially with credits and the same license
- Contact original creator for any commercial licensing excluding the holes and horns.
- Photos by me are CC BY-SA 4.0
- Optional: If this was of use to you or if you made something based on it please tell me about it!
Tags
Model origin
The author remixed this model.
