Phone Stand (Fud Version): Minimal and Sturdy Phone Stand

The Fud Phone Stand can be printed without supports.  It will definitely test the bridging performance of your printer, but should come out just fine.  A little sagging of the first layer or two of the top cross bar is likely, but doesn't affect the overall functionality or quality of the stand.  I've had success with both PLA and PETG prints of this model.

The intent of my design is to produce something functional, simple and modern, while using less filament than other designs.  It is sturdy and should last the end user a long time.

material: PLA or PETG

layer height: 0.2mm

infill: 15% (minimum)

supports: none