BTT TFT35 V3 Mount for CR6

Case and mount for the BTT TFT35 V3, for use on the Creality CR6-SE. There two mounts included, one for the left side of the printer, and one for the right side. For use with the BTT SKR CR6 aftermarket motherboard.

2-28-21 -Edit: Uploaded a new F3d file, and a new STL (Base2). Thanks to ProwlerOn for pointing out an error in the stl, parts of the base extended too far down. Fixed!

Print Settings

Printer Brand:

Creality

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20

Filament:

Crystal

Notes:

I used Cura Supports, everywhere, 10%, on the base and top. Depending on your printer, you might not need them.

Used M3x6 (4) for mounting the TFT to the enclosure, M3x12 (2) for attaching the base to the mount, with washers and nuts. Used M3x10 to attach top to base (2). Reuse existing fasteners for attaching mount to printer.

Used M3 Female Thread Knurled Nuts Brass Threaded Insert (6) , from amazon. m3x4x5 (4mm long, 5mm OD.) Gently heated with a soldering iron and press in. The design has 5mm guides around the holes, to help with alignment. It doesn't take much heat to insert them.

EDIT: I bought the following 18" extended cables from Amazon. This allowed mounting the case on the right side, but just barely. Really need to find a 24" cable. https://www.amazon.com/gp/product/B07VPF61RQ/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1