Denture Bit Holder With Magnets!

Uploaded Version 2_3! I've made the hinges much beefier & added locking indents on the hinge so it will snap close & open!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Fits standard 6.35mm or 0.25in (flat to flat) drill bits.

Pause the print at ~5.3mm (will vary slightly depending on your print settings) height to insert the 8x3mm magnets.

Supplies needed:

• 28x 8x3mm round rare-earth magnets 
•   2x M5x16 Screws 
•   2x M5 Nuts
•   2x M5 Washers

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Some tips for working with the magnets:

Lay all the magnets out so they stick to each other on their sides before printing. Mark the tops of all the magnets with a sharpie (insert the magnets sequentially according to this order)

Pick up the individual magnets using the flat of something like an allen wrench

Try applying a dab of super glue to the bottom side of each magnet just before inserting them. The heated bed really makes the glue dry fast.

While inserting magnets, cover the nearest magnet holes that already have magnets inserted with your finger to prevent a magnet you're working with from flipping over.

Thank you, Kady DIY, for the assembly video!!! https://www.youtube.com/watch?v=SarClqWDwrE

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Update 2024-11-03: The etsy listing hasn't been active for a few years now.  
New version for sale on Etsy: https://www.etsy.com/listing/960829496/denture-driver-bit-holder
(The version for sale uses no part of the thing listed here on thingiverse)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~