Quadcopter prop puller - 4blade

Metal fork propeller pullers are difficult to use and results in the risk of broken or bent quadcopter components.  This 3D print requires user to pull along the axis of the motor shaft, so no bending occurs.

One end of print is for CW and other is for CCW propeller spin direction.  Device is pressed until hooks engage the straight section of the underside of two opposing propellers.  User applies pressure with one finger to hold hooks/device in place while pulling propeller off the motor shaft.

Must be printed horizontally.  Use supports from print bed only.  Layer height = 0.2mm and infill = 15%.

Printed in PETG.