Monopoly Jail Cell
Monopoly Jail Cell
Published 2018-05-16T12:34:27+00:00
Monopoly Jail Cell
This is a Jail Cell for the Monopoly board games. It is designed to fit in the jail cell space on the original board game, but it should also fit other editions with a standard jail space. It is printed in two parts; base/bars and cap.
Disclaimer
Although I usually print at a layer height of .1mm, the cell in the picture was printed at .2mm because most people seem to print at that layer height. I also used the cheap fillament that came with my printer to print this, as I didn't want to waste my hatchbox fillament. So the bars have a bunch of fairly large start/stop marks, on which I only spent about a minute trying to clean up. Also, the cap was only pressed into place and not epoxied, as I'd normally do. So with quality fillament, finer printer settings, and a few minutes spent cleaning up, this jail cell will look much better.
General Printer Settings
Layer Height .2mm
Top/Bottom/Perimeter 3 layers
Infill 20%
Time 1h 03 m
Fillament Length 3124.9 mm
Platic Weight 9.40 g
Date published | 16/05/2018 |
Technology | FDM |
Complexity | Easy |