Prusa i3 MK2 GoPro Session Mount (longer)

This is a Remix of the original "Prusa i3 mk2 Yi Sport Camera holder" which you can find here:
http://www.thingiverse.com/thing:1704137

Since I wanted to attach my Gopro Session to the Prusa Printer I designed a new camera bed. It is designed such that the Gopro Session fits just tight and kind of 'clicks' into it.

As well as the bed I remixed the original "sliding_bracket.stl" to be about 20mm longer. Therefore you don't have to worry about your extruder crashing into your camera anymore! This change leads to the fact that you now actually see the bracket slider in the captured gopro image (See Image above). But of course you might just cut the relevant section of your videos/pictures in post video processing.

The remaining parts like Screw and Nut are the same. As mentioned in the original things comment, I also encountered some problems turning the screw into the nut, since it appeared to be designed very tight. Make sure to print the screw with high infill (I used 100%) and then repeat tighten and loosen the screw again and again until the screw is coming though the nut once. Finally you should be able to turn the screw just perfectly.

Have Fun!