Big thanks to AGuyFromOhio for actually doing the hard work and designing the case I remixed this from (on Thingiverse: https://www.thingiverse.com/thing:2533064). I'm using it since over a year now and I'm super happy with it. I ended up re-designing the case in Fusion360 and added a few things like a tent kit and printable key caps.
Attention: This is still a work in progress (small details might change) but I verified that the case fits the PCBs I linked below and that top and bottom parts fit together well.
All information on the original Ergodox project is available here.
1. Adjustable to your needs/peference with Fusion360
2. Try colors before printing
3. Fits the official Ergodox PCB design
4. Tent Kit with adjustable angles
5. Printable Key Caps
Case - I simply measured on the STL files shared by AGuyFromOhio and replicated the case bit by bit in Fusion360.
Plate - No history available yet. I only converted the STL in Fusion360, got rid of the triangles and fixed things that broke, here and there. If you want a different layout, you can simply extrude the current cutouts that you don't want and then add a new sketch on the top surface to add your own adjustments.
Tent Kit - The angles are adjustable, simply change the "angle" parameter in Fusion360. I'm using 15 degrees on the renders published here.
Key Caps - I designed those without any template, just measured the Cherry MX profile on one of the switches I had and optimized until they fit. The design itself does not follow any official widely available key type.
1. Make sure the case did not warp during the print. If the top surfaces come out a bit rough, you might want to file them a little so the top and bottom part close properly. Also verify that the ports of your PCB are accessible by the mini USB and the 3.5mm TRRS plugs.
2. Add 8 brass inserts each to the top parts of the case. Make sure the ones you use work with 3.8mm holes. Be very careful inserting them as any excess melting will prevent top and bottom parts to fit together well.
3. If you use the tent kit, add 4 feet each to the tents. If you choose to use the keyboard without the tent kit, add 5 feet each to the designated cutouts on the bottom parts.
I bought my PCB and electronics through Falbatech in Poland (great service!) and soldered it all together to safe some money (it also was a lot of fun). You can also add the cables needed to the PCBs on their shop:
The instructions on how to solder everything together and how to configure the firmware can be found here
Rubber Feet x10 (12mm max. diameter, 5mm height)
M3 brass inserts x16
M3x14mm socket head screws x6 (if the tent kit is used, will replace x6 M3x6mm screws)
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%
Filament: Anything you like
I used these switches for my assembly in fusion: https://grabcad.com/library/cherry-mx-series-key-keycap-1
Category: DIY
The author marked this model as their own original creation. Imported from Thingiverse.