Prusa MMU2 PTFE Tubes Separator 4mm O.D. tubes

Clips together really easily and holds all 5 PTFE tubes securely without deforming them. Printed fine for me on my Prusa in PLA and could use any filament type.
If shrinkage causes holes to be too small it deforms the tubing then either ream them out with two halves clipped together or print again and make it bigger in the slicer.

On the original STL files there is a clearance of 50 micron between the dovetails on each half and this printed fine for me on my Prusa but it has been pointed out that this is not enough clearance on all printers / printer settings so I have now included a second set of STL files with 0.1 mm clearance on the dovetails and 0.1 mm bigger diameter holes to allow for more shrinkage of the parts after printing.

If this is still not enough clearance for your printer or printer settings let me know.

G-Code files added for 0.05 mm and 0.1 mm clearance files in PLA and PETG.

Layer Height 0.2 mm
Perimeters 2
Infill 20%
Supports No
Brim Not Necessary