Qidi X-Plus Spool Mount

Spool holder for the Qidi X-Plus. This uses the factory spool holder cradles to secure the mounts and the can be used in either direction(using the tube on the rear top or over the top of the machine with or with the cover on. Spool width is about 3-1/2 inches. This puts a standard spool hanging about 5 inches behind the machine.

This was remixed from another remix holder made for another machine I believe the original was 1832235 just searching back.

You will need:
Both mount sides(they are mirrored).
4 of the bearing pins that may need to be glued(if loose but mine were a press fit).
4 standard 608 skate bearings.
10 inches of 3/4" schedule 40 pvc pipe
4 standard schedule 40 3/4" PVC coupler (trim a few mm off of one end of each if you want more spool space and adjust the pipe length)
4 standard 3/4" to 1/2" bushings

I got all of the PVC parts in for right at $5USD
Alternatively you can print https://www.thingiverse.com/thing:3854517 Chad made and they should fit just right.

Print Settings

Printer:

Qidi X-Plus

Rafts:

No

No

Resolution:

.2

15% or higher

Notes:

With enough infill for strength and a few bottom layers you can use 0 top layers to leave the infill exposed for a nice look.