Egg stand / holder

This is my egg stand design. It is symetrical, so you can turn it upside down. There are two stl files with custom supports. One with gap of 0,1mm to the support and the second with gap 0,2 mm. 0,1mm works for me fine. But you can still print it without these custom supports by removing them in the slicer.

Even PLA can handle the "heat" from hot egg in this case ;).

Also check out:

https://www.youtube.com/channel/UChKp-968z1i5PN29gbR7YfA

https://www.cgtrader.com/rorys3d