Ikea Morkradd adjustable light cover

This is an adjustable cover for Ikea MÖRKRÄDD lights.
Included 2 main parts:
Inner cap
Outer cap (+"infill" panels or use the solid outer cap if you want)

Both parts just snap to each other and are pressure fitted to the lamp itself (no glue needed). Rotate the outer cap to control the amount of light passing through.

You can adjust the panels look by placing them on top of the outer cap in your slicer and set an override for them to use no walls/top/bottom layers so it will only be printed using infill (see picture).

Only the panels needs any kind of infill, the rest is setup to be multiplies of 0.4mm lines.

Note: if the cap is too tight, scale it up a bit on x/y.

Print Settings

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

50 (Panels only)