Prusa MK2 Trash Bin for Purge Lines and such

Old purge lines and filament change leftovers always seem to end up under and around the printer. This is an attempt to solve that problem.

Important: This part snaps to the M10 rods of the older (pre Mk3) frame. It is not compatible with the aluminum extrusions of the Mk3. (I know the plate says MK3, but it is a Mk2.5, still a rod frame printer.)

• Symmetrical design, can be used on either side
• Opening designed to keep the most stubborn wisps of filament trapped.
• Prints without supports

Originally published in 2019: https://www.thingiverse.com/thing:3611527 

Category: 3D Printer Accessories